enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Metric drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

4. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. Orders of magnitude (length) - Wikipedia

   en.wikipedia.org/wiki/Orders_of_magnitude_(length)

   To help compare different orders of magnitude, this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm). 1.0 mm – 1/1,000 of a meter; 1.0 mm – 0.03937 inches or 5/127 (exactly) 1.0 mm – side of a square of area 1 mm²; 1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27]

6. Millimetre - Wikipedia

   en.wikipedia.org/wiki/Millimetre

   On a metric ruler, the smallest measurements are normally millimetres. [3] High-quality engineering rulers may be graduated in increments of 0.5 mm. Digital callipers are commonly capable of reading increments as small as 0.01 mm. [4] Microwaves with a frequency of 300 GHz have a wavelength of 1

7. Metrication in the United States - Wikipedia

   en.wikipedia.org/wiki/Metrication_in_the_United...

   Computer fan sizes are exclusively referred to by metric units (120 mm or 80 mm case fans, for example), while hard disk drive and CD drive bay sizes are customary measurements, typically 3 1 ⁄ 2 inches and 5 1 ⁄ 4 inches, respectively. The actual size of the drive bays differ from their name (e.g., 3 1 ⁄ 2" drive bays are actually 4 ...