Search results
Results from the WOW.Com Content Network
In electrical engineering, a limit switch is a switch operated by the motion of a machine part or the presence of an object. A limit switch can be used for controlling machinery as part of a control system , as a safety interlock , or as a counter enumerating objects passing a point.
This control method may call for control inputs that go against the pilot's instinct: when the aircraft is in a dive, adding thrust will raise the nose and vice versa. Additionally, asymmetrical thrust has been used for directional control: if the left engine is idled and power is increased on the right side this will result in a yaw to the ...
In many cases, it is possible to design a relay logic diagram directly from the narrative description of a control event sequence. In general, the following suggestions apply to designing a relay logic diagram: 1. Define the process to be controlled. 2. Draw a sketch of the operation process. Make sure all the components of the system are ...
The key can then be used to unlock the kiln door. While the key is removed from the switch interlock, a plunger from the interlock mechanically prevents the switch from closing. Power cannot be re-applied to the kiln until the kiln door is locked, releasing the key, and the key is then returned to the disconnecting switch interlock. [1]
Ladder notation is best suited to control problems where only binary variables are required and where interlocking and sequencing of binary is the primary control problem. Like all parallel programming languages , the sequential order of operations may be undefined or obscure; logic race conditions are possible which may produce unexpected results.
Elevators with more than 30 m (98 ft) of travel have a system called compensation. This is a separate set of cables or a chain attached to the bottom of the counterweight and the bottom of the elevator cab. This makes it easier to control the elevator, as it compensates for the differing weight of cable between the hoist and the cab.
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.