Search results
Results from the WOW.Com Content Network
A limit switch with a roller-lever operator; this is installed on a gate on a canal lock, and indicates the position of a gate to a control system A limit switch mounted on a moving part of a bridge In electrical engineering , a limit switch is a switch operated by the motion of a machine part or the presence of an object.
This control method may call for control inputs that go against the pilot's instinct: when the aircraft is in a dive, adding thrust will raise the nose and vice versa. Additionally, asymmetrical thrust has been used for directional control: if the left engine is idled and power is increased on the right side this will result in a yaw to the ...
Elevators' effect on pitch Elevator and pitch trim tab of a light aircraft. Elevators are flight control surfaces, usually at the rear of an aircraft, which control the aircraft's pitch, and therefore the angle of attack and the lift of the wing. The elevators are usually hinged to the tailplane or horizontal stabilizer.
It is a Midland Railway signal box dating from 1899, although the original mechanical lever frame has been replaced by electrical switches. Seen here in 2009. Seen here in 2009. On a rail transport system, signalling control is the process by which control is exercised over train movements by way of railway signals and block systems to ensure ...
MULTI is the first cable-less elevator developed by TK Elevator (formerly ThyssenKrupp Elevator). Rather than using cables to lift the elevator, MULTI uses linear motors. [1] As well as moving vertically between floors of a building, MULTI can also move horizontally through a floor of a building. MULTI is being tested at Rottweil Test Tower. [2 ...
A switch disconnector combines the properties of a disconnector and a load switch, [1] so it provides the safety isolation function while being able to make and break nominal currents. Integrated disconnecting switch
5 position trim system. A variable-position horizontal stabilizer changes the pitch simultaneously with the flaperon setting. Normally the horizontal stabilizer also known as tailplane is fixed and has a hinged elevator, a stabilator is another method that combines the functions of an elevator and a horizontal stabilizer.
It pushes the elevator control forward as the stall is approached, causing a reduction in the angle of attack. In generic terms, a stick pusher is known as a stall identification device or stall identification system. [73] A stick shaker is a mechanical device that shakes the pilot's controls to warn of the onset of stall.