Search results
Results from the WOW.Com Content Network
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip , often encased in a tubular glass bulb to protect it from dust or short circuit .
The electric heat in defrost mode is needed to keep the system from blowing cold air inside the building. The elements are then used in the "reheat" function. Although the thermostat may indicate the system is in defrost and electric heat is activated, the defrost function is not controlled by the thermostat.
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
The heat (wattage) selector switch is at the top right. The switch at the bottom is a normally open switch that serves as a "tipover switch" safety device: as long as the heater is standing upright, the switch is engaged and the circuit is closed. The grip for the power cord is at the bottom right. Overheat cutouts
Radiant systems, encompassing both heating and cooling, transfer heat or coolness directly through surfaces, such as floors, ceilings, or walls, instead of relying on forced-air systems. These systems are broadly categorized into three types: [19] thermally activated building systems (TABS), [20] embedded surface systems, and radiant ceiling ...
A combined refrigerator/freezer which applies self-defrosting to the refrigerator compartment only is usually called "partial frost free" or semi-automatic defrost (some brands call these "Auto Defrost" while Frigidaire referred to their semi-automatic models as "Cycla-Matic," Kelvinator often named these models as "Cyclic Defrost" ). These ...
A mercury switch is an electrical switch that opens and closes a circuit when a small amount of the liquid metal mercury connects metal electrodes to close the circuit. There are several different basic designs (tilt, displacement, radial, etc.) but they all share the common design strength of non-eroding switch contacts.
A heat sink then absorbs the heat released by the refrigerant due to its loss of entropy. Thermal contact with the heat sink is then broken so that the system is insulated, and the magnetic field is switched off. This increases the heat capacity of the refrigerant, thus decreasing its temperature below the temperature of the heat sink.