Search results
Results from the WOW.Com Content Network
Fuel and oxygen tanks should be fastened securely and upright to a wall, post, or portable cart. An oxygen tank is especially dangerous because the gas is stored at a pressure of 21 MPa (3,000 psi; 210 atm)) when full. If the tank falls over and damages the valve, the tank can be jettisoned by the compressed oxygen escaping the cylinder at high ...
Oxygen tanks containing pressures of up to 200 bar (3000 psi) are used for industrial processes including the manufacturing of steel and monel, welding and cutting, medical breathing gas, diving and as an emergency breathing gas in aircraft. A small steel tank of 16 litres water capacity with a working pressure of 139 bar (2015 psi), holds ...
Medical use liquid oxygen airgas tanks are typically 2.4 MPa (350 psi). [citation needed] All equipment coming into contact with high pressure oxygen must be "oxygen clean" and "oxygen compatible", to reduce the risk of fire. [3] [4] "Oxygen clean" means the removal of any substance that could act as a source of ignition. "Oxygen compatible ...
A gas cylinder is used to store gas or liquefied gas at pressures above normal atmospheric pressure. [2] In South Africa, a gas storage cylinder implies a refillable transportable container with a water capacity volume of up to 150 litres. Refillable transportable cylindrical containers from 150 to 3,000 litres water capacity are referred to as ...
An oxygen concentrator is a device that concentrates the oxygen from a gas supply (typically ambient air) by selectively removing nitrogen to supply an oxygen-enriched product gas stream. They are used industrially, to provide supplemental oxygen at high altitudes, and as medical devices for oxygen therapy .
The pin index safety system uses a face seal between the cylinder valve and the associated yoke clamp. There are two holes in specific positions on the cylinder valve body below the outlet port , in positions associated with the gas mixture, which prevent connection of the cylinder to a yoke or pressure regulator with a mis-matched set of pins.
The system can be flushed with an inert gas to reduce the concentration of oxygen so that when the flammable gas is admitted, an ignitable mixture cannot form. In NFPA 56, [1] this is known as purge-into-service. In combustion engineering terms, the admission of inert gas dilutes the oxygen below the limiting oxygen concentration.
Oxy-fuel combustion has significant advantages over traditional air-fired plants. Among these are: The mass and volume of the flue gas are reduced by approximately 75%. Because the flue gas volume is reduced, less heat is lost in the flue gas. The size of the flue gas treatment equipment can be reduced by 75%.