Search results
Results from the WOW.Com Content Network
ARINC 429, [1] the "Mark 33 Digital Information Transfer System (DITS)," is the ARINC technical standard for the predominant avionics data bus used on most higher-end commercial and transport aircraft. [2] It defines the physical and electrical interfaces of a two-wire data bus and a data protocol to support an aircraft's avionics local area ...
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
Typically a command byte is sent requesting a response in dual mode, after which the MOSI line becomes SIO0 (serial I/O 0) and carries even bits, while the MISO line becomes SIO1 and carries odd bits. Data is still transmitted most-significant bit first, but SIO1 carries bits 7, 5, 3 and 1 of each byte, while SIO0 carries bits 6, 4, 2 and 0.
Bus (computing), a communication system that transfers data between different components in a computer or between different computers Memory bus, a bus between the computer and the memory; PCI bus, a bus between motherboard and peripherals that uses the Peripheral Component Interconnect standard
The bus speed in DOLLx8 network is managed by the CLK signal and are currently set to 36kHz, which represents 14 milliseconds between each clock pulse. The bus clock is controlled by a positive BSEL- signal (BSEL + goes then simultaneously negative or low) and remains high as long as there is data in the data buffer memory.
HyperTransport comes in four versions—1.x, 2.0, 3.0, and 3.1—which run from 200 MHz to 3.2 GHz. It is also a DDR or "double data rate" connection, meaning it sends data on both the rising and falling edges of the clock signal. This allows for a maximum data rate of 6400 MT/s when running at 3.2 GHz.
There is only one Bus Controller at a time on any MIL-STD-1553 bus. It initiates all message communication over the bus. Figure 1 shows 1553 data bus details: operates according to a command list stored in its local memory; commands the various Remote Terminals to send or receive messages; services any requests that it receives from the Remote ...
Bidirectional communication with two unidirectional lines; Point-to-point or multi-slave networks; Maximum user data rate, transmission data depending on driver and line of e.g. RS-422: 10 MHz, 1 km; LVDS: 100 Mbit/s; Independent of the applied physical layer; CRC secured communication (sensor data and control data secured separately) [8]