enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. MHV connector - Wikipedia

   en.wikipedia.org/wiki/MHV_connector

   Comparison of male and female MHV connectors (left) with BNC (right) MHV connectors are a safety hazard because the central pin is close enough to the end to allow accidental contact with it when the connector is not plugged in, [5] [6] [3] and because the ground connection is broken before the power connection when demating.

3. Coaxial power connector - Wikipedia

   en.wikipedia.org/wiki/Coaxial_power_connector

   EIAJ-04 and 05 have an internal male pin in the plug. The 01 through 03 sizes do not and are similar to the generic plugs in structure. These five EIAJ plugs are 9.5 mm in length and have a current rating of 2A. There are two other, less common, connectors defined by EIAJ; RC-5321 and RC-5322.

4. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

5. TV aerial plug - Wikipedia

   en.wikipedia.org/wiki/TV_aerial_plug

   Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.

6. SMC connector - Wikipedia

   en.wikipedia.org/wiki/SMC_connector

   SMC jack connectors have an external thread while SMC plug connectors have the mating hex nut. The contact dimensions are identical to the snap-fit SMB. Available in 50 ohm and 75 ohm characteristic impedance, they provide an interconnect means for small form factor coaxial cables (e.g. 50 ohm RG-174 , 75 ohm RG-179 ) and printed circuit boards ...

7. GR connector - Wikipedia

   en.wikipedia.org/wiki/GR_connector

   The GR connector, officially the General Radio Type 874, was a type of RF connector used for connecting coaxial cable. Designed by Eduard Karplus, Harold M. Wilson and William R. Thurston at General Radio Corporation. [1] It was widely used on General Radio's electronic test equipment and some Tektronix instruments from the 1950s to the 1970s. [2]