enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Category 5 cable that is partially stripped and showing its four twisted pairs (eight wires). Category 5 cable (Cat 5) is a twisted pair cable for computer networks.Since 2001, the variant commonly in use is the Category 5e specification (Cat 5e).

3. Patch cable - Wikipedia

   en.wikipedia.org/wiki/Patch_cable

   A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.

4. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...

5. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

6. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...