enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Single-ended triode - Wikipedia

   en.wikipedia.org/wiki/Single-ended_triode

   A SET tube audio amplifier. A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted signals added and the distortion components subtracted.

3. Single-ended signaling - Wikipedia

   en.wikipedia.org/wiki/Single-ended_signaling

   Single-ended signaling is the simplest and most commonly used method of transmitting electrical signals over wires. One wire carries a varying voltage that represents the signal, while the other wire is connected to a reference voltage, usually ground .

4. Push–pull output - Wikipedia

   en.wikipedia.org/wiki/Push–pull_output

   A Single Ended Push–Pull (SEPP, SRPP or mu-follower [10]) output stage, originally called the Series-Balanced amplifier (US patent 2,310,342, Feb 1943). is similar to a totem-pole arrangement for transistors in that two devices are in series between the power supply rails, but the input drive goes only to one of the devices, the bottom one of ...

5. Operational amplifier - Wikipedia

   en.wikipedia.org/wiki/Operational_amplifier

   An operational amplifier (often op amp or opamp) is a DC-coupled electronic voltage amplifier with a differential input, a (usually) single-ended output, [1] and an extremely high gain. Its name comes from its original use of performing mathematical operations in analog computers .

6. Power amplifier classes - Wikipedia

   en.wikipedia.org/wiki/Power_amplifier_classes

   To achieve this rail tracking control, T2 and T4 act as current amplifiers, each in series with its low voltage counterpart T1 and T3. The purpose of T2 and T3 is to allow back-biasing diode D2 when the amplifier output is at a positive peak (above 39.3 V) and back biasing D4 when the output is at negative peak less than -39.3 V.

7. KT88 - Wikipedia

   en.wikipedia.org/wiki/KT88

   Historically, it has been far more popular with high fidelity stereo manufacturers than guitar amplifier builders, given its characteristics of high-power and low-distortion. Due to these characteristics, it is regularly used to replace 6550 tubes by end users seeking a guitar amplifier tone with less distortion. [ 6 ]