Search results
Results from the WOW.Com Content Network
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
Pin No (DB25) Pin No (36 pin) Signal name Direction Register - bit Inverted 1 1 Strobe In/out Control-0 Yes 2 2 Data0 Out Data-0 No 3 3 Data1 Out Data-1 No 4 4 Data2 Out Data-2 No 5 5 Data3 Out Data-3 No 6 6 Data4 Out Data-4 No 7 7 Data5 Out Data-5 No 8 8 Data6 Out Data-6 No 9 9 Data7 Out Data-7 No 10 10 Ack In Status-6 No 11 11 Busy In Status-7
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
Currently known as TIA-530-A, but often called EIA-530, or RS-530, is a balanced serial interface standard that generally uses a 25-pin connector, originally created by the Telecommunications Industry Association. Finalized in 1987 (revision A finalized in 1992 [1]), the specification defines the cable between the DTE and DCE devices.
Male pinout of a 25-pin serial port (D-subminiature, DB-25) commonly found on 1980s computers. The following table lists commonly used RS-232 signals (called "circuits" in the specifications) and their pin assignments on the recommended DB-25 connectors [14] (see Serial port pinouts for other commonly used connectors not defined by the standard).
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.