Search results
Results from the WOW.Com Content Network
At first, Adaptec focused on devices with Parallel SCSI interfaces. Popular host bus adapters included the 154x/15xx ISA family, the 2940 PCI family, and the 29160/-320 family. Their cross-platform ASPI was an early API for accessing and integrating non- disk devices like tape drives , scanners and optical disks .
Adaptec also developed generic SCSI disk and CD-ROM drivers for DOS (ASPICD.SYS and ASPIDISK.SYS). [ 3 ] : 60–61 At least a couple of other programming interfaces for SCSI device drivers competed with ASPI in the early 1990s, including CAM (Common Access Method), developed by Apple; and Layered Device Driver Architecture, developed by Microsoft .
SCSI-2 was introduced in 1994 and gave rise to the Fast SCSI and Wide SCSI variants. Fast SCSI doubled the maximum transfer rate to 10 MB/s while retaining the same 50-pin cables, while Wide SCSI doubled the bus width to 16 bits on top of that to reach a maximum transfer rate of 20 MB/s, using new 68-pin cables.
The ancestral SCSI standard, X3.131-1986, generally referred to as SCSI-1, was published by the X3T9 technical committee of the American National Standards Institute (ANSI) in 1986. SCSI-2 was published in August 1990 as X3.T9.2/86-109, with further revisions in 1994 and subsequent adoption of a multitude of interfaces.
A stack of external SCSI devices displaying various SCSI connectors. Parallel SCSI (SCSI Parallel Interface SPI) allows for attachment of up to 8 devices (8-bit Narrow SCSI) or 16 devices (16-bit Wide SCSI) to the SCSI bus. The SCSI Host controller takes up one slot on the SCSI bus, which limits the number of devices allowed on the bus to 7 or ...
In Fibre Channel, the port identifier is a WWPN and the device name is a WWNN. In SAS, both SCSI port identifiers and SCSI device names take the form of a SAS address, which is a 64 bit value, normally in the NAA IEEE Registered format. People sometimes refer to a SCSI port identifier as the SAS address of a device, out of confusion. People ...
The SCSI target usually exports one or more LUNs for initiators to operate on. The LIO Linux SCSI Target implements a generic SCSI target that provides remote access to most data storage device types over all prevalent storage fabrics and protocols. LIO neither directly accesses data nor does it directly communicate with applications.
Fibre Channel was designed as a serial interface to overcome limitations of the SCSI and HIPPI physical-layer parallel-signal copper wire interfaces. Such interfaces face the challenge of, among other things, maintaining signal timing coherence across all the data-signal wires (8, 16 and finally 32 for SCSI, 50 for HIPPI) so that a receiver can ...