Search results
Results from the WOW.Com Content Network
The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI (Open Systems Interconnection) network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer.
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet. It is a dynamic table that maps MAC addresses to ports.
Hop-by-hop is the fundamental characteristic of the IP Internet layer [1] and the OSI Network Layer. When a router interface is configured with an IP address and subnet mask, the interface becomes a host on that attached network. A directly connected network is a network that is directly attached to one of the router interfaces.
L2F Layer 2 Forwarding Protocol; L2TP Layer 2 Tunneling Protocol; LLDP Link Layer Discovery Protocol; LLDP-MED Link Layer Discovery Protocol - Media Endpoint Discovery; MAC Media Access Control; Q.710 Simplified Message Transfer Part; Multi-link trunking Protocol; NDP Neighbor Discovery Protocol; PAgP - Cisco Systems proprietary link ...
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
Networks are separated from each other by specialized hosts, called gateways or routers with specialized software support optimized for routing. IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing ...
When an interface has an address configured in a subnet, such as 192.0.2.1 in the 192.0.2.0/24 (i.e., subnet mask 255.255.255.0) subnet, and that interface is considered "up" by the router, the router thus has a directly connected route to 192.0.2.0/24. If a routing protocol offered another router's route to that same subnet, the routing table ...
RFC 2992 analyzed one particular multipath routing strategy involving the assignment of flows through hashing flow-related data in the packet header. This solution is designed to avoid these problems by sending all packets from any particular network flow through the same path while balancing multiple flows over multiple paths in general. [2]