Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
Electronic stability control (ESC), also referred to as electronic stability program (ESP) or dynamic stability control (DSC), is a computerized technology [1] [2] that improves a vehicle's stability by detecting and reducing loss of traction . [3]
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed bowden cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
An ECU from a Geo Storm. An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.