enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

3. Hella (company) - Wikipedia

   en.wikipedia.org/wiki/Hella_(company)

   The Special Applications Segment serves target groups ranging from the producers of construction machinery through boat builders right up to municipalities and energy suppliers by providing them with innovative lighting and electronic products. [4] In the lighting division, Hella develops and manufactures headlamps, rear lamps, and interior ...

4. Wedge base - Wikipedia

   en.wikipedia.org/wiki/Wedge_base

   In Europe, bulbs using wedge base connectors are often referred to by the designations the World Forum for Harmonization of Vehicle Regulations has assigned to them, like P27/7W for W2.5x16q when used as a combined 27 and 7 watt light bulb intended for position, brake and turn lights in vehicles. LED bulbs are also made that will retrofit ...

5. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

6. Parabolic aluminized reflector - Wikipedia

   en.wikipedia.org/wiki/Parabolic_aluminized_reflector

   The size of a round PAR lamp is expressed as the nominal diameter of the mouth of the reflector, in eighths of an inch—so the approximate nominal lamp bell diameter in inches can be found by dividing the PAR size by 8. A PAR56, for example, is 56 eighths of an inch (7 inches) in diameter; a PAR36 is 36 eighths (4.5 inches) in diameter, and so on.

7. Headlamp - Wikipedia

   en.wikipedia.org/wiki/Headlamp

   As previously with round lamps, the US permitted only two standardized sizes of rectangular sealed-beam lamp: A system of two 200 by 142 mm (7.9 by 5.6 in) high/low beam units corresponding to the existing 7-inch round format, or a system of four 165 by 100 mm (6.5 by 3.9 in) units, two high/low and two high-beam. corresponding to the existing ...