Ad
related to: strap top conversion system for water heater troubleshootingplumbertoday.co has been visited by 10K+ users in the past month
- Schedule Service
Call Us 7 Days a Week.
Fast Plumbing Repair / Install Pros
- Toilet Repair
Fix Your Toilet Now.
Same / Next Day Service, Call Now.
- Drain Clog Repair
Drain Unclogging Services
Top Local Plumbing Pros.
- Commercial Plumbing
Top Commercial Plumbers
Full Service Plumbing Experts
- Schedule Service
Search results
Results from the WOW.Com Content Network
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.
The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.
The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.
Direct electric resistance tank water heaters are not included in the Energy Star program; however, the Energy Star program does include electric heat pump units with energy factors of 200% or higher. Tankless gas water heaters (as of 2015) must have an energy factor of 90% or higher for Energy Star qualification.
'S' trap inlet to drain [further explanation needed]. The air lock phenomenon can be used in a number of useful ways. An 'S' trap (a pipe that descends from a reservoir, then curves back up, then down again) allows liquid to flow from top to bottom unhindered, and gas cannot flow through the trap unless it has enough extra pressure to overcome the liquid head of the trap.
The pneumatic control signals are traditionally based on a pressure range of 3–15 psi (0.2–1.0 bar), or more commonly now, an electrical signal of 4-20mA for industry, or 0–10 V for HVAC systems. Electrical control now often includes a "Smart" communication signal superimposed on the 4–20 mA control current, such that the health and ...
A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.
Ad
related to: strap top conversion system for water heater troubleshootingplumbertoday.co has been visited by 10K+ users in the past month