Search results
Results from the WOW.Com Content Network
Kirchhoff's current law is the basis of nodal analysis. In electric circuits analysis, nodal analysis, node-voltage analysis, or the branch current method is a method of determining the voltage (potential difference) between "nodes" (points where elements or branches connect) in an electrical circuit in terms of the branch currents.
In electronics, a current divider is a simple linear circuit that produces an output current (I X) that is a fraction of its input current (I T). Current division refers to the splitting of current between the branches of the divider. The currents in the various branches of such a circuit will always divide in such a way as to minimize the ...
The nodal admittance matrix is a matrix such that bus voltage and current injection satisfy Ohm's law = in vector format. The entries of are then determined by the equations for the current injections into buses, resulting in
The generality is extended when and are linear operations on the set of potential differences and on the set of branch currents (respectively) since linear operations don't affect KVL and KCL. For instance, the linear operation may be the average or the Laplace transform .
When X L equals X C, the two branch currents are equal and opposite. They cancel each other out to give minimal current in the main line (in principle, for a finite voltage V, there is zero current). Since total current in the main line is minimal, in this state the total impedance is maximal.
In power engineering, the power-flow study, or load-flow study, is a numerical analysis of the flow of electric power in an interconnected system. A power-flow study usually uses simplified notations such as a one-line diagram and per-unit system, and focuses on various aspects of AC power parameters, such as Voltage, voltage angles, real power and reactive power.
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.
The open-circuit test, or no-load test, is one of the methods used in electrical engineering to determine the no-load impedance in the excitation branch of a transformer. The no load is represented by the open circuit, which is represented on the right side of the figure as the "hole" or incomplete part of the circuit.