Search results
Results from the WOW.Com Content Network
Nails are made in a great variety of forms for specialized purposes. The most common is a wire nail. [2] Other types of nails include pins, tacks, brads, spikes, and cleats. Nails are typically driven into the workpiece by a hammer or nail gun. A nail holds materials together by friction in the axial direction and shear strength
This is the most common form of the butt joint in building construction. Members are brought together and a number of nails are driven in to hold them in place. The technique of skew-nailing is applied so that nails are not parallel to each other and so resist the pulling apart of the joint. [2]
A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.
The Crane Group Companies (also known as Crane Group) of Columbus, Ohio, USA, is a holding company of operating units primarily involved in the manufacturing and distribution of building products.
Glulam brace with plates used for connections Glulam frame of a roof structure. Glued laminated timber, commonly referred to as glulam, is a type of structural engineered wood product constituted by layers of dimensional lumber bonded together with durable, moisture-resistant structural adhesives so that all of the grain runs parallel to the longitudinal axis.
Core Molding Technologies, Inc. was founded in 1988 (its original name was Core Materials Corporation) and now based in Columbus, Ohio.The company manufactures sheet molding compounds (SMC), and molds fiberglass reinforced plastics.
Illustration of carpentry (charpente) in the French Encyclopédie showing hewing, mortising, pit sawing on trestles. Tools include dividers, axes, chisel and mallet, beam cart, pit saw, trestles, and bisaigue.
A typical plywood panel has face veneers of a higher grade than the core veneers. The principal function of the core layers is to increase the separation between the outer layers where the bending stresses are highest, thus increasing the panel's resistance to bending. As a result, thicker panels can span greater distances under the same loads.