enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Metal lathe - Wikipedia

   en.wikipedia.org/wiki/Metal_lathe

   The compound rest (or top slide) (2) is usually where the tool post is mounted. It provides a smaller amount of movement (less than the cross-slide) along its axis via another feedscrew. The compound rest axis can be adjusted independently of the carriage or cross-slide.

3. Tool and cutter grinder - Wikipedia

   en.wikipedia.org/wiki/Tool_and_cutter_grinder

   The tool itself consists of three parts: The grinder head, work table, and holding fixture. The grinder head has three degrees of freedom. Vertical movement, movement into the workpiece, and tilt. These are generally set statically, and left fixed throughout operations. The work table is a T-slotted X-axis table mounted on top of a radial fixture.

4. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   Vertical milling machine. 1: milling cutter 2: spindle 3: top slide or overarm 4: column 5: table 6: Y-axis slide 7: knee 8: base. In the vertical milling machine the spindle axis is vertically oriented. Milling cutters are held in the spindle and rotate on its axis. The spindle can generally be lowered (or the table can be raised, giving the ...

5. Rotary table - Wikipedia

   en.wikipedia.org/wiki/Rotary_table

   Rotary tables are most commonly mounted "flat", with the table rotating around a vertical axis, in the same plane as the cutter of a vertical milling machine.An alternate setup is to mount the rotary table on its end (or mount it "flat" on a 90° angle plate), so that it rotates about a horizontal axis.

6. Lapping - Wikipedia

   en.wikipedia.org/wiki/Lapping

   The lap or lapping plate in this machine is 30 cm (12 in) in diameter, about the smallest size available commercially. At the other end of the size spectrum, machines with 2.4-to-3.0-metre-diameter (8 to 10 ft) plates are not uncommon, and systems with tables 9 m (30 ft) in diameter have been constructed.

7. Way (machine tool element) - Wikipedia

   en.wikipedia.org/wiki/Way_(machine_tool_element)

   The geometry of the way can vary depending on the situation. The most common types are flat, vee, and dovetail ways. Flat ways are used when there is little requirement for the slide to be constrained perpendicular to the axis of movement, or the constraint is being provided by another component or otherwise not needed, such as on the carriage of a lathe.