Search results
Results from the WOW.Com Content Network
In computer engineering, instruction pipelining is a technique for implementing instruction-level parallelism within a single processor. Pipelining attempts to keep every part of the processor busy with some instruction by dividing incoming instructions into a series of sequential steps (the eponymous "pipeline") performed by different processor units with different parts of instructions ...
This process is much faster than sending out an address, reading the opcode and then decoding and executing it. Fetching the next instruction while the current instruction is being decoded or executed is called pipelining. [8] The 8086 processor has a six-byte prefetch instruction pipeline, while the 8088 has a four-byte prefetch. As the ...
Intel's second generation of 32-bit x86 processors, introduced built-in floating point unit (FPU), 8 KB on-chip L1 cache, and pipelining. Faster per MHz than the 386. Small number of new instructions. P5
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 [citation needed] and June 8, 1978, when it was released. [5] The Intel 8088, released July 1, 1979, [6] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM ...
Will change OperandSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. 67h: AddressSize override. Will change AddressSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. The 80386 also introduced the two new segment registers FS and GS as well as the x86 control, debug and test registers.
One of these could be filled by the optional R2010 floating-point unit (FPU), which had thirty-two 32-bit registers that could be used as sixteen 64-bit registers for double-precision. The R3000 succeeded the R2000 in 1988, adding 32 KB (soon raised to 64 KB) caches for instructions and data, and support for shared-memory multiprocessing in the ...
The primary defining characteristic of IA-32 is the availability of 32-bit general-purpose processor registers (for example, EAX and EBX), 32-bit integer arithmetic and logical operations, 32-bit offsets within a segment in protected mode, and the translation of segmented addresses to 32-bit linear addresses. The designers took the opportunity ...
In simpler CPUs, the instruction cycle is executed sequentially, each instruction being processed before the next one is started. In most modern CPUs, the instruction cycles are instead executed concurrently, and often in parallel, through an instruction pipeline: the next instruction starts being processed before the previous instruction has finished, which is possible because the cycle is ...