Search results
Results from the WOW.Com Content Network
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Although flange fittings are bulky, they perform well in demanding applications such as large water supply networks and hydroelectric systems. Flanges are rated at 150, 300, 400, 600, 900, 1500, and 2500 psi; or 10, 15, 25, 40, 64, 100, and 150 bars of pressure. Various types of flanges are available, depending on construction.
Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.
PTFE tape used for different sized fittings PTFE tape for natural gas. There are two US standards for determining the quality of any thread seal tape. MIL-T-27730A (an obsolete military specification still commonly used in industry in the US) requires a minimum thickness of 3.5 mils and a minimum PTFE purity of 99%. [3]
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...
In mechanical engineering, a compression seal fitting, also known as a sealing gland, is intended to seal some type of element (probe, wire, conductor, pipe, tube, fiber-optic cable, etc.) when the element must pass through a pressure or environmental boundary. [1]
The only way to obtain the actual OD is to look it up in a reference table. For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is ...