Search results
Results from the WOW.Com Content Network
The top of descent is usually calculated by an on-board flight management system, and is designed to provide the most economical descent to approach altitude, or to meet some other objective (fastest descent, greatest range, etc.). The top of descent may be calculated manually as long as distance, air speed, and current altitude are known. This ...
In aviation, the rule of three or "3:1 rule of descent" is a rule of thumb that 3 nautical miles (5.6 km) of travel should be allowed for every 1,000 feet (300 m) of descent. [1] [2] For example, a descent from flight level 350 would require approximately 35x3=105 nautical miles.
The top of climb may be calculated manually with considerable effort. [ 1 ] Alternatively, when manual planning and monitoring a VFR flight, TOC is an elegant and efficient way for a pilot to eliminate all the vaguery and variability of departing any airport (the turns assigned, changes of runway the pilot cannot control).
An onboard navigation system displays a constant rate descent path to minimums. The VNAV path is computed using aircraft performance, approach constraints, weather data, and aircraft weight. The approach path is computed from the top of descent point to the end of descent waypoint, which is typically the runway or missed approach point. [1]
The simplified formulas above are based on a trigonometric calculation: Rate of descent = ground speed × 101.27 × tan α. where: α is the descent or glideslope angle from the horizontal (3° being the standard) 101.27 (ft/min ⁄ kn) is the conversion factor from knots to feet per minute (1 knot = 1 NM ⁄ h ≈ 6076 ft ⁄ h ≈ 101.27 ft ...
This becomes very useful for estimating or correcting vertical speed settings and flight path angles (FPA) during climb, descent, or approaches. If a gradient in % is required, the numbers work out with the same rule: 1% over 1 NM ≈ 60'
In aeronautics, a descent is any time period during air travel where an aircraft decreases altitude, and is the opposite of an ascent or climb.. Descents are part of normal procedures, but also occur during emergencies, such as rapid or explosive decompression, forcing an emergency descent to below 3,000 m (10,000 ft) and preferably below 2,400 m (8,000 ft), respectively the maximum temporary ...
Schematic descent profile of a conventional approach (red) and a continuous descent approach (green). Continuous descent approach (CDA), also known as optimized profile descent (OPD), is a method by which aircraft approach airports prior to landing. It is designed to reduce fuel consumption and noise compared to other conventional descents.