Search results
Results from the WOW.Com Content Network
The two primary methods of deformation in metals are slip and twinning. Slip occurs by dislocation glide of either screw or edge dislocations within a slip plane. Slip is by far the most common mechanism. Twinning is less common but readily occurs under some circumstances. Twinning occurs when there are not enough slip systems to accommodate ...
A slip system describes the set of symmetrically identical slip planes and associated family of slip directions for which dislocation motion can easily occur and lead to plastic deformation. The magnitude and direction of slip are represented by the Burgers vector , b .
The deformation field at the slip-band is due to three-dimensional elastic and plastic strains where the concentrated shear of the slip band tip deforms the grain in its vicinity. The elastic strains describe the stress concentration ahead of the slip band , which is important as it can affect the transfer of plastic deformation across grain ...
Plasticity in a crystal of pure metal is primarily caused by two modes of deformation in the crystal lattice: slip and twinning. Slip is a shear deformation which moves the atoms through many interatomic distances relative to their initial positions.
In materials science, Schmid's law (also Schmid factor [a]) describes the slip plane and the slip direction of a stressed material, which can resolve the most shear stress. ...
These values vary with deformation temperature, strain rate and chemical composition. [ 3 ] [ 4 ] Researchers have shown that increased work hardening attributed to the partitioning of the austenite grains is the main contributing factor to the overall elongation of TWIP steels in which the mechanical strain of twinning have a rather small ...
Sample deformation mechanism map for a hypothetical material. Here there are three main regions: plasticity, power law creep, and diffusional flow. A deformation mechanism map is a way of representing the dominant deformation mechanism in a material loaded under a given set of conditions. The technique is applicable to all crystalline materials ...
While undergoing deformation, slip motion will take place. Grain boundaries act as an impediment to dislocation motion for the following two reasons: 1. Dislocation must change its direction of motion due to the differing orientation of grains. [4] 2. Discontinuity of slip planes from grain one to grain two. [4]