enow.com Web Search

  1. Ads

    related to: 1.5 inch rope clamp tool

Search results

  1. Results from the WOW.Com Content Network
  2. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  3. Glossary of firefighting equipment - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_firefighting...

    A forcible entry tool for removing cylinder locks; used with a Halligan bar. It is a larger version of a K-tool. Rabbit tool Hydraulic spreading tool that is specially designed to open doors that swing inward. [15] Red line See booster hose Reducer Adapter used to attach a larger diameter source hose to a smaller diameter receiving hose.

  4. .308×1.5-inch Barnes - Wikipedia

    en.wikipedia.org/wiki/.308×1.5-inch_Barnes

    The .308×1.5" Barnes is a wildcat cartridge based on the .308 Winchester (7.62×51mm NATO). The cartridge is similar to the 7.62×39mm Russian (M43) cartridge though it outperforms the Soviet cartridge. [2]

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 22 ] : 149 [ 19 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

  6. Rope splicing - Wikipedia

    en.wikipedia.org/wiki/Rope_splicing

    Rope splicing in ropework is the forming of a semi-permanent joint between two ropes or two parts of the same rope by partly untwisting and then interweaving their strands. Splices can be used to form a stopper at the end of a line, to form a loop or an eye in a rope, or for joining two ropes together. [ 1 ]

  7. Chuck (engineering) - Wikipedia

    en.wikipedia.org/wiki/Chuck_(engineering)

    A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

  1. Ads

    related to: 1.5 inch rope clamp tool