Search results
Results from the WOW.Com Content Network
The intermodulation between frequency components will form additional components at frequencies that are not just at harmonic frequencies (integer multiples) of either, like harmonic distortion, but also at the sum and difference frequencies of the original frequencies and at sums and differences of multiples of those frequencies.
The frequency range handled by an amplifier might be specified in terms of bandwidth (normally implying a response that is 3 dB down when the frequency reaches the specified bandwidth), or by specifying a frequency response that is within a certain number of decibels between a lower and an upper frequency (e.g. "20 Hz to 20 kHz plus or minus 1 ...
If the frequency deviation is held constant and the modulation frequency increased, the spacing between spectra increases. Frequency modulation can be classified as narrowband if the change in the carrier frequency is about the same as the signal frequency, or as wideband if the change in the carrier frequency is much higher (modulation index ...
The bandwidth (also called the 3 dB frequency) is the frequency where the signal drops to 1/ √ 2 of its low-frequency value. (In decibels, dB(√ 2) = 3.01 dB). A reduction to 1/ √ 2 occurs when ωC M R A = 1, making the input signal at this value of ω (call this value ω 3 dB, say) v G = V A / (1+j).
The period (symbol T) is the interval of time between events, so the period is the reciprocal of the frequency: T = 1/f. [2] Frequency is an important parameter used in science and engineering to specify the rate of oscillatory and vibratory phenomena, such as mechanical vibrations, audio signals , radio waves, and light.
SASERs could have wide applications. Apart from facilitating the investigation of terahertz-frequency ultrasound, the SASER is also likely to find uses in optoelectronics (electronic devices that detect and control light—as a method of transmitting a signal from an end to the other of, for instance, fiber optics), as a method of signal modulation and/or transmission.
The operation of a lock-in amplifier relies on the orthogonality of sinusoidal functions.Specifically, when a sinusoidal function of frequency f 1 is multiplied by a sinusoidal function of another frequency f 2 and integrated over a time much longer than the period of the two functions, the result is close to zero.
Peak-to-peak amplitude (abbreviated p–p or PtP or PtoP) is the change between peak (highest amplitude value) and trough (lowest amplitude value, which can be negative). With appropriate circuitry, peak-to-peak amplitudes of electric oscillations can be measured by meters or by viewing the waveform on an oscilloscope .