Search results
Results from the WOW.Com Content Network
The clock rate of a CPU is normally determined by the frequency of an oscillator crystal. Typically a crystal oscillator produces a fixed sine wave —the frequency reference signal. Electronic circuitry translates that into a square wave at the same frequency for digital electronics applications (or, when using a CPU multiplier , some fixed ...
In PCs, the CPU's external address and data buses connect the CPU to the rest of the system via the "northbridge". Nearly every desktop CPU produced since the introduction of the 486DX2 in 1992 has employed a clock multiplier to run its internal logic at a higher frequency than its external bus, but still remain synchronous with it. This ...
BogoMips is a value that can be used to verify whether the processor in question is in the proper range of similar processors, i.e. BogoMips represents a processor's clock frequency as well as the potentially present CPU cache. It is not usable for performance comparisons among different CPUs. [4]
For a given processor, C is a fixed value. However, V and f can vary considerably. For example, for a 1.6 GHz Pentium M, the clock frequency can be stepped down in 200 MHz decrements over the range from 1.6 to 0.6 GHz. At the same time, the voltage requirement decreases from 1.484 to 0.956 V.
The frequency at which a processor (CPU) operates is determined by applying a clock multiplier to the front-side bus (FSB) speed in some cases. For example, a processor running at 3200 MHz might be using a 400 MHz FSB. This means there is an internal clock multiplier setting (also called bus/core ratio) of 8. That is, the CPU is set to run at 8 ...
Tulsa was released in two lines: the N-line uses a 667 MT/s FSB, and the M-line uses an 800 MT/s FSB. The N-line ranges from 2.5 GHz to 3.5 GHz (model numbers 7110N-7150N), and the M-line ranges from 2.6 GHz to 3.4 GHz (model numbers 7110M-7140M). L3 cache ranges from 4 MB to 16 MB across the models. [12]
512 KB 1 ⁄ 2 frequency external L2 cache; ... Used in high-performance and mid-range dual processor enabled workstations; Xeon 2.0 GHz and up to 3.6 GHz
Overclocking BIOS setup on an ABIT NF7-S motherboard with an AMD Athlon XP processor. Front side bus (FSB) frequency (external clock) has been increased from 133 MHz to 148 MHz, and the CPU clock multiplier factor has been changed from 13.5 to 16.5. This corresponds to an overclocking of the FSB by 11.3 percent and of the CPU by 36 percent.