Search results
Results from the WOW.Com Content Network
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The GM Ecotec engine, also known by its codename L850, is a family of all-aluminium inline-four engines, displacing between 1.2 and 2.5 litres.Confusingly, the Ecotec name was also applied to both the Buick V6 Engine when used in Holden Vehicles, as well as the final DOHC derivatives of the previous GM Family II engine; the architecture was substantially re-engineered for this new Ecotec ...
The Family II is a straight-4 piston engine that was originally developed by Opel in the 1970s, debuting in 1981. Available in a wide range of cubic capacities ranging from 1598 to 2405 cc, it simultaneously replaced the Opel CIH and Vauxhall Slant-4 engines, and was GM Europe's core mid-sized powerplant design for much of the 1980s, and provided the basis for the later Ecotec series of ...
Starting around 1925 engine blocks and cylinder heads were now developed at each brand but were cast at Saginaw Metal Casting Operations. [3] In the mid-1960s, there were 8 separate families of GM V8 engines on sale in the USA. [4] [1] By the 1970s, GM began to see problems with their approach.
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
The LD9 Twin Cam was a 2.4-liter Quad 4 variant which debuted in 1996 with balance shafts and a redesigned cylinder head. In the mid-1990s, these engines, like their earlier 2.3-liter counterparts, were known for timing chain failures, as well as water pump failures, in which the water pumps were often difficult and costly to access and replace.
GM claims that the EcoTec three-cylinder idles more smoothly than Ford's three-cylinder, which does not use a shaft. [2] All turbocharged variants provide 90 percent of their maximum torque between 1500 and 5000 rpm, with peak power arriving between 5600 and 6000 rpm. The MHI turbochargers are sized to provide quick torque response, and are ...
Originally designed and produced by General Motors (GM Ecotec Diesel), replaced by Isuzu and Fiat engines. SIDI (Spark Ignition Direct Injection) Ecotec – petrol Medium Gasoline Engine produced by Adam Opel AG. EcoTec3 is the name used on General Motors' Small Block Gen 5 Engines. All include direct injection, cylinder deactivation, and ...