Search results
Results from the WOW.Com Content Network
It is proportional to the number of elements in the chart and is given by 1/N, N being the total number of elements in the chart. For example, a typical chart consists of 200 elements; therefore, the influence value is 0.005. [1] The procedure for obtaining the vertical pressure at any point below a loaded area is as follows:
If a soil is loaded beyond this point the soil is unable to sustain the increased load and the structure will break down. [4] This breakdown can cause a number of different things depending on the type of soil and its geologic history. Preconsolidation pressure cannot be measured directly, but can be estimated using a number of different ...
where is the equivalent stress, is the pressure, is the pre-consolidation pressure, and is the slope of the critical state line in space. The pre-consolidation pressure evolves as the void ratio ( e {\displaystyle e} ) (and therefore the specific volume v {\displaystyle v} ) of the soil changes.
The compression index C c, which is defined as the change in void ratio per 10-fold increase in consolidation pressure, is in the range of 0.19 to 0.28 for kaolinite, 0.50 to 1.10 for illite, and 1.0 to 2.6 for montmorillonite, for different ionic forms. [7]
The tendency for a soil to dilate or contract depends primarily on the confining pressure and the void ratio of the soil. The rate of dilation is high if the confining pressure is small and the void ratio is small. The rate of contraction is high if the confining pressure is large and the void ratio is large.
An example of lateral earth pressure overturning a retaining wall. The lateral earth pressure is the pressure that soil exerts in the horizontal direction. It is important because it affects the consolidation behavior and strength of the soil and because it is considered in the design of geotechnical engineering structures such as retaining walls, basements, tunnels, deep foundations and ...
Matric suction: the defining trait of unsaturated soil, this term corresponds to the pressure dry soil exerts on the surrounding material to equalise the moisture content in the overall block of soil and is defined as the difference between pore air pressure, (), and pore water pressure, (). [2]
The soil sample in an oedometer test is typically a circular disc of diameter-to-height ratio of about 3:1. The sample is held in a rigid confining ring, which prevents lateral displacement of the soil sample, but allows the sample to swell or compress vertically in response to changes in applied load.