Search results
Results from the WOW.Com Content Network
File Allocation Table (FAT) is a file system developed for personal computers and was the default filesystem for the MS-DOS and Windows 9x operating systems. [citation needed] Originally developed in 1977 for use on floppy disks, it was adapted for use on hard disks and other devices.
Because file size references are stored in eight instead of four bytes, the file size limit has increased to 16 exabytes (EB) (2 64 − 1 bytes, or about 10 19 bytes, which is otherwise limited by a maximum volume size of 128 PB, [nb 2] or 2 57 − 1 bytes), raised from 4 GB (2 32 − 1 bytes) in a standard FAT32 file system. [1]
Originally, the FAT ID was meant to be a bit flag with all bits set except for bit 2 cleared to indicate an 80 track (vs. 40 track) format, bit 1 cleared to indicate a 9 sector (vs. 8 sector) format, and bit 0 cleared to indicate a single-sided (vs. double-sided) format, [7] but this scheme was not followed by all OEMs and became obsolete with ...
A block, a contiguous number of bytes, is the minimum unit of storage that is read from and written to a disk by a disk driver.The earliest disk drives had fixed block sizes (e.g. the IBM 350 disk storage unit (of the late 1950s) block size was 100 six-bit characters) but starting with the 1301 [8] IBM marketed subsystems that featured variable block sizes: a particular track could have blocks ...
With the release of Mac OS X Snow Leopard, and before that, since the move to 64-bit architectures in general, some software publishers such as Mozilla [1] have used the term "universal" to refer to a fat binary that includes builds for both i386 (32-bit Intel) and x86_64 systems. The same mechanism that is used to select between the PowerPC or ...
At power-up or card insertion, the voltage on pin 1 selects either the Serial Peripheral Interface (SPI) bus or the SD bus. The SD bus starts in one-bit mode, but the host device may issue a command to switch to the four-bit mode, if the SD card supports it. For various card types, support for the four-bit SD bus is either optional or mandatory ...
The helpers are 16-bit (for OS/2 1.x) or 32-bit (for OS/2 2.x and up), are executed in user-space and contain the code used for typical filesystem maintenance, and are called by CHKDSK and FORMAT utilities. This four-piece scheme allowed developers to dynamically add a new bootable filesystem, as the ext2 driver for OS/2 demonstrated.
A basic data partition can be formatted with any file system, although most commonly BDPs are formatted with the NTFS, exFAT, or FAT32 file systems. To programmatically determine which file system a BDP contains, Microsoft specifies that one should inspect the BIOS Parameter Block that is contained in the BDP's Volume Boot Record .