Search results
Results from the WOW.Com Content Network
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input to its output . It is a class of switched-mode power supply (SMPS) containing at least two semiconductors, a diode and a transistor , and at least one energy storage element: a capacitor , inductor , or the two in ...
The input is left side, the output with load is right side. The switch is typically a MOSFET, IGBT, or BJT transistor. A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply.
Step down chopper Step up chopper Range of output voltage: 0 to V volts: V to +∞ volts Position of chopper switch: In series with load: In parallel with load Expression for output voltage: VL dc = D × V volts: V o = V/(1 – D) volts External inductance: Not required: Required for boosting the output voltage Use: For motoring operation, for ...
Switching converters or switched-mode DC-to-DC converters store the input energy temporarily and then release that energy to the output at a different voltage, which may be higher or lower. The storage may be in either magnetic field storage components (inductors, transformers) or electric field storage components (capacitors).
For this reason, the two inductors can be wound on the same core, which begins to resemble a flyback converter, the most basic of the transformer-isolated switched-mode power supply topologies. Since the voltages are the same in magnitude, their effects on the mutual inductance will be zero, assuming the polarity of the windings is correct.
The Vienna Rectifier provides the following features: Three-phase three-level three-switch PWM rectifier with controlled output voltage [3] Three-wire input, no connection to neutral; Ohmic mains behaviour [4] Boost system (continuous input current) Unidirectional power flow [5] High power density
The main disadvantage is the high current stress on the switch. [4] Fig. 1: Cuk converter circuit diagram. The capacitor C 1 is used to transfer energy. It is connected alternately to the input and to the output of the converter via the commutation of the transistor and the diode (see figures 2 and 3).