enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel truing stand - Wikipedia

   en.wikipedia.org/wiki/Wheel_truing_stand

   Two-armed wheel truing stand One-armed wheel truing stand. A wheel truing stand is a specialized tool for "truing" (straightening) bicycle wheels. [1] [2] Individual models differ slightly, but all consist of an axle stand on which the wheel can rotate and calipers, to measure slight deviations of the wheel's rim from ideal alignment.

3. Bicycle tools - Wikipedia

   en.wikipedia.org/wiki/Bicycle_tools

   Dishing gauge is used to measure the dish of a wheel. Wheel truing stand is used to measure the side to side and radial trueness of a wheel's rim and facilitate truing it. Bicycle pump; Pressure gauge is used to measure tire pressure. Hub, wheel and tire tools

4. List of bicycle parts - Wikipedia

   en.wikipedia.org/wiki/List_of_bicycle_parts

   Portage strap: a strap (usually made of leather) attached to the inside of the bike frame, designed to make carrying the bike over one's shoulder easier; Pulley wheel: see Jockey wheel; Power meter: a device on a bicycle that measures the power output of the rider; Quick release: a skewer with a lever on one end that loosens when the lever is ...

5. Bicycle wheel - Wikipedia

   en.wikipedia.org/wiki/Bicycle_wheel

   "29-inch wheels", which also conform to the popular 700C (622 mm diameter clincher) wheel standard are becoming more popular for not only cyclocross bikes but also cross-country mountain bikes. Their rim diameter of 622 millimetres ( 24 + 1 ⁄ 2 in) is identical to most road, hybrid, and touring bicycle wheels, but they are typically ...

6. Wheelie - Wikipedia

   en.wikipedia.org/wiki/Wheelie

   Motorcycle wheelie Wheelie at a tractor pull Wheelie at a drag race Manual on a BMX bike. A wheelie, or wheelstand, [1] is a vehicle maneuver in vehicle acrobatics in which the front wheel or wheels come off the ground due to sufficient torque being applied to the rear wheel or wheels, [2] or rider motion relative to the vehicle.

7. Rupp Industries - Wikipedia

   en.wikipedia.org/wiki/Rupp_Industries

   L – Rupp manufactured two L-series dirt bikes in 1973, the L80 and L100. Both bikes used 2-cycle Fuji engines, in 80 and 100cc sizes. They were equipped with four- and five-speed manual transmissions, respectively. SS – The SS-5 was Rupp's only dirt bike that used a Tecumseh engine and automatic transmission. The engine was a Tecumseh HS50 ...