Search results
Results from the WOW.Com Content Network
For thousands of years ship designers and builders of sailing vessels used rules of thumb based on the midship-section area to size the sails for a given vessel. The hull form and sail plan for the clipper ships, for example, evolved from experience, not from theory. It was not until the advent of steam power and the construction of large iron ...
Simpson's rules are used to calculate the volume of lifeboats, [6] and by surveyors to calculate the volume of sludge in a ship's oil tanks. For instance, in the latter, Simpson's 3rd rule is used to find the volume between two co-ordinates. To calculate the entire area / volume, Simpson's first rule is used. [7]
Schematic of quantities for capstan equation An example of holding capstans and a powered capstan used to raise sails on a tall ship. The capstan equation [ 1 ] or belt friction equation , also known as Euler–Eytelwein formula [ 2 ] (after Leonhard Euler and Johann Albert Eytelwein ), [ 3 ] relates the hold-force to the load-force if a ...
Ship stability is an area of naval architecture and ship design that deals with how a ship behaves at sea, both in still water and in waves, whether intact or damaged. Stability calculations focus on centers of gravity , centers of buoyancy , the metacenters of vessels, and on how these interact.
Hull speed can be calculated by the following formula: where is the length of the waterline in feet, and is the hull speed of the vessel in knots. If the length of waterline is given in metres and desired hull speed in knots, the coefficient is 2.43 kn·m −½.
For US waters, the US Code of Federal Regulations require ships and their masters to calculate UKC based on the ship's deepest navigational draft. 33 CFR 157.450 The regulations require the master to discuss the UKC calculation with the maritime pilot as the ship approaches US ports/waters. 33 CFR 157.450
The strength of ships is a topic of key interest to naval architects and shipbuilders. Ships which are built too strong are heavy, slow, and cost extra money to build and operate since they weigh more, whilst ships which are built too weakly suffer from minor hull damage and in some extreme cases catastrophic failure and sinking.
In a flight simulator, it is possible to "look up" new values for stability and control derivatives as conditions change. And so, the "linear approximations" aren't as great and stability can be assessed in maneuvers that span a greater range of flight conditions. Flight simulators used for analysis such as this are called "engineering simulators".