Search results
Results from the WOW.Com Content Network
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but not more than 96 inches (244 cm) apart. [10] Axles spaced less than 40 inches (102 cm) apart are considered a single axle. [11] In effect, the formula reduces the legal weight limit for shorter trucks with fewer axles (see table below
The Military Load Classification (MLC) is a system of standards used by NATO to classify the safe amount of load a surface can withstand. Load-carrying capacity is shown in whole numbers for vehicles, bridges, roads, and routes. Vehicles are classified by weight, type, and effect on routes.
The change in material stress deforms the sensor, in which strain gauges are mounted as in a classic load cell. Thus, the weight of the individual wheelset or bogie can be calculated from the specific deformation behaviour of the rail. Advantages: Can be used as a wheel load scale and axle load scale,
The axle load will not usually be the sum of the two wheel loads because the line of action of the cross-balancing will be different in each wheel. [26] With the locomotive's static weight known the amount of overbalance which may be put into each wheel to partially balance the reciprocating parts is calculated. [ 27 ]
Route availability for a vehicle (locomotive or wagon) is generally based upon its axle loading. That is, how much of the laden weight of the vehicle is distributed on each axle. The more weight on each axle, the higher the RA number, and the more restricted the vehicle is. For wagons it is normal to have different RAs when running empty and full.
When evaluating the series of tests, it was found that there is a connection between the thickness of the pavement, the number of load transfers and the axle load, and that these have a direct effect on the service life and condition of a road. The service life of the road is thereby reduced with approximately the fourth power of the axle load. [1]
The axles indicated by a single letter or number are mounted on a bogie. Parentheses Groups letters and numbers describing the same bogie. For example, (A1A) indicates a three-axle bogie with the outer two axles driven. When parentheses are used around a single letter or number, a prime is not needed to indicate a bogie.