enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 6 things you should do to make sure your air conditioner is ...

   www.aol.com/news/6-things-sure-air-conditioner...

   When an air conditioning unit or system is working in tip top shape, you might forget to even think about it but when the system is down, the whole house will feel it. So, here are some tips for ...

3. Register (air and heating) - Wikipedia

   en.wikipedia.org/wiki/Register_(air_and_heating)

   Dampers also allow air to be shut off in unused rooms, improving the efficiency of the HVAC system. Dampers can also help adjust a HVAC system for seasonal use. [7] During winter months, for example, an air conditioning register can be closed to prevent cold air from being pulled from the room.

4. Damper (flow) - Wikipedia

   en.wikipedia.org/wiki/Damper_(flow)

   This damper can switch the electrical power to control additional "slave" dampers, minimizing the electrical load on the damper's control circuitry and power transformer. A zone damper (also known as a Volume Control Damper or VCD) is a specific type of damper used to control the flow of air in an HVAC heating or cooling system. In order to ...

5. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Rooftop HVAC unit with view of fresh-air intake vent Ventilation duct with outlet diffuser vent. These are installed throughout a building to move air in or out of rooms. In the middle is a damper to open and close the vent to allow more or less air to enter the space.

6. Testing, adjusting, balancing - Wikipedia

   en.wikipedia.org/wiki/Testing,_adjusting,_balancing

   In heating, ventilation, and air conditioning (HVAC), testing, adjusting and balancing (TAB) are the three major steps used to achieve proper operation of heating, ventilation, and air conditioning systems. TAB usually refers to commercial building construction and the specialized contractors who employ personnel that perform this service.

7. Duct leakage testing - Wikipedia

   en.wikipedia.org/wiki/Duct_leakage_testing

   A pressure 5 Pa or above indicates that the duct work is connected to or leaking to the outside. A smaller pressure difference indicates greater leakage. This method does not quantify duct leakage, but serves to identify locations of ductwork runs that are leaking to the outside. It is more of a qualitative measure, used for fault isolation.