enow.com Web Search

  1. Ads

    related to: fuel injection pressure tester kit cp7818 2 speed engine repair

Search results

  1. Results from the WOW.Com Content Network
  2. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    The same engine at sea level will achieve that same 50 kPa (7.25 psi, 14.7 inHG) of manifold pressure at less than (before reaching) WOT due to the higher barometric pressure. The engine requires the same mass of fuel in both conditions because the mass of air entering the cylinders is the same. If the throttle is opened all the way in ...

  3. Rochester Ramjet - Wikipedia

    en.wikipedia.org/wiki/Rochester_Ramjet

    The Ramjet is a continuous-flow port-injection system. Unlike later fuel injection systems that used electronics, this one is based on purely mechanical principles. The two main sub-assemblies of the system are the air meter and the fuel meter. The air meter measures airflow into the engine and manages thermostatic warmup enrichment, fuel ...

  4. Fuel injection - Wikipedia

    en.wikipedia.org/wiki/Fuel_injection

    Also in 1957, General Motors introduced the Rochester Ramjet option, consisting of a fuel injection system for the V8 engine in the Chevrolet Corvette. During the 1960s, fuel injection systems were also produced by Hilborn, [46] SPICA [47] and Kugelfischer. Up until this time, the fuel injection systems had used a mechanical control system.

  5. Crankshaft position sensor - Wikipedia

    en.wikipedia.org/wiki/Crankshaft_position_sensor

    A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.

  6. On-board diagnostics - Wikipedia

    en.wikipedia.org/wiki/On-board_diagnostics

    0 – Fuel and air metering and auxiliary emission controls; 1 – Fuel and air metering; 2 – Fuel and air metering (injector circuit) 3 – Ignition systems or misfires; 4 – Auxiliary emission controls; 5 – Vehicle speed control and idle control systems; 6 – Computer and output circuit; 7 – Transmission; 8 – Transmission; A-F ...

  7. Manifold injection - Wikipedia

    en.wikipedia.org/wiki/Manifold_injection

    The atomisation quality is relative to the injection pressure, which means that a relatively low injection pressure (compared with direct injection) is sufficient for multi-point injected engines. A low injection pressure results in a low relative air-fuel velocity, which causes large, and slowly vapourising fuel droplets. [8]

  1. Ads

    related to: fuel injection pressure tester kit cp7818 2 speed engine repair