Ads
related to: gm steering shaft size chartebay.com has been visited by 1M+ users in the past month
gmpartscenter.net has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The 2nd Generation axles were driver's side with ball joints. 30 spline axle shafts were used instead of 35 splines, except 2000, 2001 and 2002 models which were equipped with 32 spline axle shafts. GM versions are passenger side differential drop, standard rotation gears, kingpin knuckles and 35 spline axle shafts.
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Power-Lok" and the "Trac-Lok."
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
2009: Single Pinion Electric Power Steering; 2010: World’s first 12-Volt Electric Power Steering Systems; 2011: Full Size Truck Rack Electric Power Steering [13] and CrossGlide Joint; 2013: Magnetic Torque Overlay; 2017: CNXMotion, a joint venture between Nexteer & Continental 2018: Advanced Steering Technology Suite, including Steer-by-Wire
Rear-axle shafts are 30 spline. The rear 11.5" has a gear ratio "carrier split" at 3.73 and numerically higher, but the General Motors AAM axles used a different carrier spacing preventing the installation of a Chrysler carrier into some GM axles, but the GM carrier can be installed in the Chrysler axle if a ring gear spacer is installed.
Ads
related to: gm steering shaft size chartebay.com has been visited by 1M+ users in the past month
gmpartscenter.net has been visited by 10K+ users in the past month