enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. These Are the Best Wrench Sets for Home Repair and Auto ... - AOL

   www.aol.com/7-best-wrench-sets-tackle-173200483.html

   A wrench set provides the versatility needed to tackle a range of nuts and bolt sizes, and the leverage to dislodge stubborn fasteners.

3. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   The tolerances necessary to make the tools usable are listed in documents such as ASME/ANSI B18.2.2 for U.S. standards. [1] For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Tamper-resistant versions with a pin in the recess are available. Metric sizes of the hex socket are defined by ISO 4762 (socket head cap screws), ISO 4026 (socket set screws with flat point), ISO 4027 (socket set screws with cone point), ISO 4028 (socket set screws with dog point), and ISO 4029 (socket set screws with cup point).

5. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   A hex key (also, hex wrench, Allen key and Allen wrench, Unbrako or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

6. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   Combination square rules are made of steel and can be purchased with gradations in metric, imperial, or both metric and imperial. Both faces of the rule have markings, providing four different sets of markings. This allows different sides to have different graduations (eg. 1mm or 0.5mm markings) or units (ie. metric and imperial).

7. Pressure angle - Wikipedia

   en.wikipedia.org/wiki/Pressure_angle

   Pressure angles. Pressure angle in relation to gear teeth, also known as the angle of obliquity, [1] is the angle between the tooth face and the gear wheel tangent. It is more precisely the angle at a pitch point between the line of pressure (which is normal to the tooth surface) and the plane tangent to the pitch surface.