Search results
Results from the WOW.Com Content Network
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
The engine has a bore and stroke of 84 mm × 90 mm (3.31 in × 3.54 in) with a compression ratio of 16.0:1, and generates 250 hp (186 kW) at 3,250 rpm and 440 lb⋅ft (597 N⋅m) of torque at 1,750 rpm, paired with a Ford–GM 10-speed automatic transmission. It provided a towing capacity of up to 11,440 lb (5,189 kg) when properly equipped.
2012–present; The 3.2 is an I5 engine used in the Ford Transit, the Ford Ranger, Ford Everest, Mazda BT-50 and the Vivarail. For the North American-spec Transit, * the 3.2 L Duratorq is modified to meet American and Canadian emissions standards and is branded as a Power Stroke engine.
The Ford FE engine is a medium block V8 engine produced by the Ford Motor Company and used in vehicles sold in the North American market between 1958 and 1976. The FE, derived from 'Ford-Edsel', [1] was introduced just four years into the short-lived Ford Y-block engine, which American cars and trucks were outgrowing. It was designed with room ...
In 1948, Ford raised the compression of the flathead six or L-6 (designated H-series or Rouge 226) so that it generated 95 hp (71 kW) and 180 lb⋅ft (244 N⋅m) of torque. The G- and H-series engines were used in the full-sized Ford cars and trucks to replace the smaller 136 cu in (2.2 L) Flathead V8 that was used in the 1937 Ford. Ford ...
The VVT is a RFF engine derived from the Mazda MZI and does not have the mechanical buckets as on the Lincoln LS version. [citation needed] The engine has an output of 221 bhp (165 kW; 224 PS) at 6250 rpm, and 205 lb⋅ft (278 N⋅m) of torque at 4800 rpm. In second generation of the engine, it is updated to run on E85.
Introduced for the Thailand-built 2007 Ford Ranger (J97U) is a 2.5 L diesel engine. This truck is a clone of the Mazda B-Series and thus the engine is a Mazda engine. It has a bore and a stroke of 93 mm × 92 mm (3.66 in × 3.62 in). The engine has no commonality to Ford's "Puma" engine or VM Motori.
The SHO engines share a common bell housing pattern with the following Ford engines: the 2.3/2.5 L FWD HSC I4, the 3.0 L FWD/RWD Vulcan V6, and the 3.8 L FWD Canadian Essex V6. [8] In 1996, Ford discontinued the SHO V6 and began fitting the Taurus SHOs with the SHO 3.4 L V8 and the Ford AX4N automatic transmission.