enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.

  3. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

  4. Template:Registered jack - Wikipedia

    en.wikipedia.org/wiki/Template:Registered_jack

    RJ11 RJ14 RJ25 Twisted pair colors 25-pair colors [A] Old colors [B] German colors [C] Australian colors Dutch colors [D] Diagram 1: 3: T + T3 white/green white/green white pink orange 6P6C connector showing the location of pin 1 2: 2: T + T2: T2 white/orange white/orange black green red orange 3: 1: R: −: R1: R1: R1 blue

  5. 600 series connector - Wikipedia

    en.wikipedia.org/wiki/600_series_connector

    600 series connectors. A 600 series connector is an obsolete three-pin connector with up to six conductors.. It was for many years the standard telephone service connector in Australia, used on rural party lines and the national Postmaster-General's Department (later Telstra) landline network, but has since the 1970s been superseded by the six position modular connector in this application.

  6. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    The 6P2C, 6P4C, and 6P6C modular connectors are probably best known for their use as RJ11, RJ14, and RJ25 non-powered registered jacks, respectively (and 6P4C and 6P6C for powered RJ11 and RJ14, power being delivered on the outer pairs). These interfaces use the same six-position modular connector body but have different numbers of pins installed.

  7. Structured cabling - Wikipedia

    en.wikipedia.org/wiki/Structured_cabling

    Equipment rooms house equipment and wiring consolidation points that serve the users inside the building or campus. Backbone cabling is the inter-building and intra-building cable connections in structured cabling between entrance facilities, equipment rooms and telecommunications closets.

  8. 25-pair color code - Wikipedia

    en.wikipedia.org/wiki/25-pair_color_code

    When used for plain old telephone service (POTS), the first wire is known as the tip or A-leg (U.K.) conductor, and is usually connected to the positive side of a direct current (DC) circuit, while the second wire is known as the ring lead or B-leg (U.K.), and is connected to the negative side of the circuit. Neither of these two sides of the ...

  9. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    A two-conductor TS phone connector. The connection to the sleeve is the rectangle towards the right, and the connection to the tip is the line with the notch. Wiring connections are illustrated as white circles. A three-conductor TRS phone connector. The upper connector is the tip, as it is farther away from the sleeve.