Search results
Results from the WOW.Com Content Network
The system power consumption is a sum of the power ratings for all of the components of the computer system that draw on the power supply. Some graphics cards (especially multiple cards) and large groups of hard drives can place very heavy demands on the 12 V lines of the PSU, and for these loads, the PSU's 12 V rating is crucial.
An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics because of their safety; the hazardous 120 or 240 volt main current is transformed down to a ...
A facility that changes electric power into some form that can be stored and usefully reconverted back to electric power, for example, pumped storage or battery systems. power supply A subsystem of a computer or other electronic device that turns electric power from a wall plug or batteries into a form suitable for use by the system.
[citation needed] Until about 1880, the paradigm for AC power transmission from a high voltage supply to a low voltage load was a series circuit. [citation needed] Open-core transformers with a ratio near 1:1 were connected with their primaries in series to allow use of a high voltage for transmission while presenting a low voltage to the lamps.
An HVDC thyristor valve tower 16.8 m tall in a hall at Baltic Cable AB in Sweden A battery charger is an example of a piece of power electronics. A PCs power supply is an example of a piece of power electronics, whether inside or outside of the cabinet. Power electronics is the application of electronics to the control and conversion of ...
This glossary of power electronics is a list of definitions of terms and concepts related to power electronics in general and power electronic capacitors in particular. For more definitions in electric engineering, see Glossary of electrical and electronics engineering.
Many computer servers offer the option of redundant power supplies, so that in the event of one power supply failing, one or more other power supplies are able to power the load. This is a critical point – each power supply must be able to power the entire server by itself.
A simple voltage dropper can be used to reduce the voltage for low-power devices; if more than 12V is required, or for high-powered devices, a switched-mode power supply is used. The output will usually be DC in the range 1.5–24 V. Power supplies that output either 100–120 V AC or 210–240 V AC are available; they are called inverters ...