Search results
Results from the WOW.Com Content Network
The alttype field allows conversion between units of different type, provided each unit is whitelisted to allow the conversion. As at December 2013, the following energy units have alttype = "torque" (the first line consists of different units, while the second line consists of aliases for units in the first line):
Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots 1 knot = 1.151 statute mile/h = 0.514 m/s 1 statute mile/h = 0.869 knots = 0.447 m/s. Note: 1 statute mile = 5,280 feet = 1,609 meters
As an example, a measured NO x concentration of 45 ppmv in a dry gas having 5 volume % O 2 is: 45 × ( 20.9 - 3 ) ÷ ( 20.9 - 5 ) = 50.7 ppmv of NO x. when corrected to a dry gas having a specified reference O 2 content of 3 volume %. Note: The measured gas concentration C m must first be corrected to a dry basis before using the above equation.
At 20 °C and 101.325 kPa, dry air has a density of 1.2041 kg/m 3. At 70 °F and 14.696 psi , dry air has a density of 0.074887 lb / ft 3 . The following table illustrates the air density–temperature relationship at 1 atm or 101.325 kPa: [ citation needed ]
The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to kilogram per cubic metre [kg/m3]. Mixed liquor is a combination of raw or unsettled wastewater or pre-settled wastewater and activated sludge within an aeration tank.
Diagram showing definitions and directions for Darcy's law. A is the cross sectional area (m 2) of the cylinder. Q is the flow rate (m 3 /s) of the fluid flowing through the area A. The flux of fluid through A is q = Q/A. L is the length of the cylinder. Δp = p outlet - p inlet = p b - p a.
An SI derived unit is a named combination of base units such as hertz (cycles per second), newton (kg⋅m/s 2), and tesla (1 kg⋅s −2 ⋅A −1) and in the case of Celsius a shifted scale from Kelvin. Certain units have been officially accepted for use with the SI.
The saturation vapor density (SVD) is the maximum density of water vapor in air at a given temperature. [1] The concept is related to saturation vapor pressure (SVP). It can be used to calculate exact quantity of water vapor in the air from a relative humidity (RH = % local air humidity measured / local total air humidity possible ) Given an RH percentage, the density of water in the air is ...