enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.

3. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes instead of having a separate nut driver for each size.

4. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   The output shaft on the cup then runs through the wheel bearing and is secured by the axle nut. This joint can accommodate the large changes of angle when the front wheels are turned by the steering system; typical Rzeppa joints allow 45°–48° of articulation, while some can give 54°. [5]

5. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

6. Semi-trailer truck - Wikipedia

   en.wikipedia.org/wiki/Semi-trailer_truck

   Conventional style cab tractor A cab-over semi-tractor Tractor with an end-dump trailer A FAW semi-trailer truck in China A semi-trailer truck (also known by a wide variety of other terms – see below) is the combination of a tractor unit and one or more semi-trailers to carry freight. A semi-trailer attaches to the tractor with a type of hitch called a fifth wheel. Other terms There are a ...

7. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   The 2nd Generation axles were driver's side with ball joints. 30 spline axle shafts were used instead of 35 splines, except 2000, 2001 and 2002 models which were equipped with 32 spline axle shafts. GM versions are passenger side differential drop, standard rotation gears, kingpin knuckles and 35 spline axle shafts.

8. M915 (truck) - Wikipedia

   en.wikipedia.org/wiki/M915_(truck)

   The more specialized trucks in the series are the M916 6x6 all wheel drive 14-Ton Light Equipment Transporter (LET) tractor with rear winch; M917 8x6 20-ton, 12 cubic yard Dump Truck; M918 6x6 22.5-ton, 1,500 gallon Bituminous Distributor; M919 8x6 22.5-ton, 8 cubic yard Concrete Mixer; and M920 8x6 20-ton Medium Equipment Transporter (MET ...

9. Center axle disconnect - Wikipedia

   en.wikipedia.org/wiki/Center_axle_disconnect

   Center axle disconnect on a Dana 60, in a 1999 4x4 Dodge 2500HD. A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles. A CAD system works by having an axle shaft (typically the longer shaft) split into two pieces.