enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   Tungsten carbide hole saw with arbor A 52 mm (2.0 in) hole saw with pilot bit A 115 mm (4.5 in) diamond hole saw. A hole saw (also styled holesaw), also known as a hole cutter, [1] is a saw blade of annular (ring) shape, whose annular kerf creates a hole in the workpiece without having to cut up the core material. It is used in a drill. Hole ...

3. Padeye - Wikipedia

   en.wikipedia.org/wiki/Padeye

   Tension failure at the sides of the hole; Crushing above the lifting pin followed by tearing tension fracture at the plate edge; Shear failure in the lug plate as the lifting pin attempts to plow its way towards the edge of the free plate; Dishing (out-of-plane buckling) failure of relatively thin lug plates that are laterally unrestrained

4. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   There are two main types of clevis pins: threaded and unthreaded. Unthreaded clevis pins have a domed head at one end and a cross-hole at the other end. A cotter pin (US usage) or split pin is used to keep the clevis pin in place. Threaded clevis pins have a partially threaded shank on one end and a formed head on the other.

5. Plate nut - Wikipedia

   en.wikipedia.org/wiki/Plate_nut

   A plate nut, also known as a nut plate, anchor nut or anchor plate, is a stamped sheet metal nut that is usually riveted to a workpiece. They have a long tube that is internally threaded and a plate with two clearance holes for rivets. The most popular versions have two lugs and they exist as fixed anchor nuts [1] and as floating anchor nuts. [2]

6. Surface plate - Wikipedia

   en.wikipedia.org/wiki/Surface_plate

   A surface plate is a solid, flat plate used as the main horizontal reference plane for precision inspection, marking out (layout), and tooling setup. [1] The surface plate is often used as the baseline for all measurements to a workpiece, therefore one primary surface is finished extremely flat with tolerances below 11.5 μm or 0.0115 mm per ...

7. Lathe faceplate - Wikipedia

   en.wikipedia.org/wiki/Lathe_faceplate

   The slotted plate on the lower photo accepts wedged holders which can be used to fasten the work to the plate. The plates were expendable, so it was not unusual as shown in both photos for a machinist to drill additional holes in the plates for attaching work that could not otherwise be attached.