Search results
Results from the WOW.Com Content Network
The voltage required to arc this distance is 327 V, which is insufficient to ignite the arcs for gaps that are either wider or narrower. For a 3.5 μm gap, the required voltage is 533 V, nearly twice as much. If 500 V were applied, it would not be sufficient to arc at the 2.85 μm distance, but would arc at a 7.5 μm distance.
An electric arc differs from a glow discharge in that the current density is quite high, and the voltage drop within the arc is low; at the cathode, the current density can be as high as one megaampere per square centimeter. [11] An electric arc has a non-linear relationship between current and voltage.
The typical relative permeability (μ r) of electrical steel is 4,000-38,000 times that of vacuum, compared to 1.003-1800 for stainless steel. [15] [16] [17] The magnetic properties of electrical steel are dependent on heat treatment, as increasing the average crystal size decreases the
Depending on the proportions of steel scrap, DRI and pig iron used, electric arc furnace steelmaking can result in carbon dioxide emissions as low as 0.6 tons CO 2 per ton of steel produced, [12] which is significantly lower than the conventional production route via blast furnaces and the basic oxygen furnace, which produces 2.9 tons CO2 per ...
I-K region: arc discharge; large amounts of radiation produced. A Townsend discharge can be sustained only over a limited range of gas pressure and electric field intensity. The accompanying plot shows the variation of voltage drop and the different operating regions for a gas-filled tube with a constant pressure, but a varying current between ...
Ferroboron (CAS Registry Number 11108–67-1) is a ferroalloy of iron and boron with boron content between 17.5 and 20%.[1]It is manufactured either by carbothermic reduction of boric acid in an electric arc furnace together with carbon steel, or by the aluminothermic reduction of boric acid in the presence of iron.
It can also be used on structural steel if certain precautions are observed, and for large cross-section aluminium busbars. [1] This process uses a direct current (DC) voltage usually ranging from about 600 A and 40-50 V, higher currents are needed for thicker materials. Because the arc is extinguished, this is not an arc process.
An induction furnace is an electrical furnace in which the heat is applied by induction heating of metal. [1] [2] [3] Induction furnace capacities range from less than one kilogram to one hundred tons, and are used to melt iron and steel, copper, aluminum, and precious metals.