Search results
Results from the WOW.Com Content Network
The simplest system bus has completely separate input data lines, output data lines, and address lines. To reduce cost, most microcomputers have a bidirectional data bus, re-using the same wires for input and output at different times. [20] Some processors use a dedicated wire for each bit of the address bus, data bus, and the control bus.
To prevent bus contention on the data bus, at any one instant only one device drives the data bus. In very simple systems, only the data bus is required to be a bidirectional bus. In very simple systems, the memory address register always drives the address bus, the control unit always drives the control bus, and an address decoder selects ...
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
ARINC 429, [1] the "Mark 33 Digital Information Transfer System (DITS)," is the ARINC technical standard for the predominant avionics data bus used on most higher-end commercial and transport aircraft. [2] It defines the physical and electrical interfaces of a two-wire data bus and a data protocol to support an aircraft's avionics local area ...
MDIO data: bidirectional, the PHY drives it to provide register data at the end of a read operation. The bus only supports a single MAC as the master, and can have up to 32 PHY slaves. The MDC can be periodic, with a minimum period of 400 ns, which corresponds to a maximum frequency of 2.5 MHz. Newer chips, however, allow faster accesses.
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
Bus (computing), a communication system that transfers data between different components in a computer or between different computers Memory bus, a bus between the computer and the memory; PCI bus, a bus between motherboard and peripherals that uses the Peripheral Component Interconnect standard
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication, where several bits are sent as a whole, on a link with several parallel channels.