enow.com Web Search

  1. Ad

    related to: asphalt binder tack coating products price

Search results

  1. Results from the WOW.Com Content Network
  2. Chipseal - Wikipedia

    en.wikipedia.org/wiki/Chipseal

    Chip seal products can be installed over gravel roads to eliminate the cost of grading, road roughness, dust, mud, and the cost of adding gravel lost from grading. Adding chip seal over gravel is about 25% of the price of resurfacing with asphalt, $170,000 for a 4-mile project done in Minnesota [6] compared to $760,000 had it been redone with ...

  3. Cool pavement - Wikipedia

    en.wikipedia.org/wiki/Cool_pavement

    This increase is also achieved by mixing in aggregates covered with cement paste and asphalt binder before pavement is laid, which creates connected pores that hold water. [4] Permeable and water-retaining pavements use a permeable material with pores grouted using blast furnace slag or pervious mortar to hold runoff water in a particular layer ...

  4. Sealcoat - Wikipedia

    en.wikipedia.org/wiki/Sealcoat

    The process is typically a two-coat application which requires 24 to 48 hours of curing before vehicles can be allowed back on the surface. Once the surface is properly prepared, then properly mixed sealer will be applied at about 1.5 square meters per liter (60 sq ft per U.S. gal; 72 sq ft per Imp gal) per coat.

  5. Otta seal - Wikipedia

    en.wikipedia.org/wiki/Otta_seal

    Otta seal is formed by adding graded aggregate to a soft bituminous binding agent. The agent is usually emulsified asphalt.Bituminous binder application rates are between 1.9 liter/m 2 (0.42 US gallon/yard 2) and 2.4 liter/m 2 (0.53 US gallon/yard 2) – the value is dependent on aggregate gradation and type.

  6. Road surface marking - Wikipedia

    en.wikipedia.org/wiki/Road_surface_marking

    Thermoplastic coatings are generally homogeneous dry mixes of binder resins, plasticizers, glass beads (or other optics), pigments, and fillers. [14] Their use has increased over paints mainly due to the performance benefits of increased durability, retro-reflectivity, and a lack of VOC solvents.

  7. Road surface - Wikipedia

    en.wikipedia.org/wiki/Road_surface

    Cold mix asphalt is often used on lower-volume rural roads, where hot mix asphalt would cool too much on the long trip from the asphalt plant to the construction site. [18] An asphalt concrete surface will generally be constructed for high-volume primary highways having an average annual daily traffic load greater than 1,200 vehicles per day. [19]

  8. Pitch (resin) - Wikipedia

    en.wikipedia.org/wiki/Pitch_(resin)

    Pitch produced from petroleum may be called bitumen or asphalt, while plant-derived pitch, a resin, is known as rosin in its solid form. Tar is sometimes used interchangeably with pitch, but generally refers to a more liquid substance derived from coal production, including coal tar , or from plants, as in pine tar .

  9. Pavement milling - Wikipedia

    en.wikipedia.org/wiki/Pavement_milling

    Pavement milling (cold planing, asphalt milling, or profiling) is the process of removing at least part of the surface of a paved area such as a road, bridge, or parking lot. Milling removes anywhere from just enough thickness to level and smooth the surface to a full depth removal.

  1. Ad

    related to: asphalt binder tack coating products price