Ads
related to: docsis wan vs ethernet switch 2
Search results
Results from the WOW.Com Content Network
DOCSIS employs a mixture of deterministic access methods for upstream transmissions, specifically time-division multiple access (TDMA) for DOCSIS 1.0/1.1 and both TDMA and S-CDMA for DOCSIS 2.0 and 3.0, with a limited use of contention for bandwidth reservation requests. In TDMA, a cable modem requests a time to transmit and the CMTS grants it ...
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Data Over Cable Service Interface Specification Provisioning of Ethernet Passive Optical Network, or DPoE, is a set of CableLabs specifications that implement the DOCSIS service layer interface on existing Ethernet PON (EPON, GEPON or 10G-EPON) media access control (MAC) and physical layer (PHY) standards. In short it implements the DOCSIS ...
DOCSIS 2.0 (cable modem) [13] 38/27 Mbit/s: ... 10 Gigabit Ethernet WAN PHY: 9.953 Gbit/s: ... IBM PC Network: 2 Mbit/s: 250 ...
The industry has made a concerted effort to resolve the limitations of Ethernet in the WAN described above, so as to allow the use of "native" Ethernet technologies by network providers. [ citation needed ] The key roles have been played by the Institute of Electrical and Electronics Engineers (IEEE) 802.1 and 802.3 standards committees.
DOCSIS 3.0 and lower — 4 Gigabit b/g/n, ac 2.4, 5.0 450 (n), ... Features an additional Ethernet port for WAN connection; features onboard memory for NAS
OSI was an industry effort, attempting to get industry participants to agree on common network standards to provide multi-vendor interoperability. [17] It was common for large networks to support multiple network protocol suites, with many devices unable to interoperate with other devices because of a lack of common protocols.
A different slave becomes active if, and only if, the active slave fails. The single logical bonded interface's MAC address is externally visible on only one NIC (port) to simplify forwarding in the network switch. This mode provides fault tolerance. XOR (balance-xor) Transmit network packets based on a hash of the packet's source and destination.
Ads
related to: docsis wan vs ethernet switch 2