enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flashing (weatherproofing) - Wikipedia

   en.wikipedia.org/wiki/Flashing_(weatherproofing)

   Shaped like a “U” or channel to catch water (e.g., where the edge of a tile roof meets a wall). Through wall flashing Spans the thickness of the wall and directs water to weep holes. Cap flashing (drip cap) Often used above windows and doors. Drip edge A metal used at the edges of a roof. Step flashing (soaker, base flashing)

3. Damp proofing - Wikipedia

   en.wikipedia.org/wiki/Damp_proofing

   A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material applied to prevent moisture transmission. A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary ...

4. Wall stud - Wikipedia

   en.wikipedia.org/wiki/Wall_stud

   sill - a stud sized member forming the base of a window assembly or the base of wall. mudsill - a stud sized member that forms the base of a wall and has been treated against insects and decay. top plate or double top plate - a stud sized member that forms the top of the wall. In cases where other members must bear or brace on the top of the ...

5. Basement waterproofing - Wikipedia

   en.wikipedia.org/wiki/Basement_waterproofing

   The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high cost of flooding. [2] Wall conduits (such as dimple boards or other membranes) are fastened to the foundation wall and extend over the new drainage to guide any moisture ...

6. Termite shield - Wikipedia

   en.wikipedia.org/wiki/Termite_shield

   The metal is formed to fit between the top of the foundation wall and the bottom of the wood sill plate. The edges of the termite shield are typically hemmed, extended slightly beyond the face of the wall, and turned down to form a drip edge which diverts water running down the face of the wall and reduce the movement of subterranean termites ...

7. Load-bearing wall - Wikipedia

   en.wikipedia.org/wiki/Load-bearing_wall

   The base plate or floor plate is the bottom attachment point for the wall studs. Using a top plate and a bottom plate, a wall can be constructed while it lies on its side, allowing for end-nailing of the studs between two plates, and then the finished wall can be tipped up vertically into place atop the wall sill; this not only improves ...