Search results
Results from the WOW.Com Content Network
V.32 (11/88) is an ITU-T recommendation for a modem operating as full-duplex on a 4-wire circuit, or half-duplex on a two-wire circuit, allowing bidirectional data transfer at either 9.6 kbit/s or 4.8 kbit/s at a symbol rate of 2,400 baud instead of the 600 baud of the V.22 standards.
This communication is done via an Ethernet crossover cable as opposed to a PC to DCE (hub, switch, or bridge) communication which is done via an Ethernet straight cable. V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment ...
A satellite modem or satmodem is a modem used to ... The LNB is usually powered by the modem through the signal cable with 13 or 18 V ... RS-422, V.35, G ...
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
DSL modem Cable modem. The term broadband was previously [55] [56] used to describe communications faster than what was available on voice grade channels. The term broadband gained widespread adoption in the late 1990s to describe internet access technology exceeding the 56 kilobit/s maximum of dialup.
The modem connected to the card used a 15-pin D-shell connector—which exactly matched the PC's game connector. Both models were powered by the PC. The new modem was frequency agile, with a configuration utility that ran on the PC to set up US and DS frequencies. The option to configure the card's MAC address was soon dropped. However, the ...
Earnings per share guidance was updated to a range of $6.10 to $6.25, compared to a previous range of $6.10 to $6.35. Barry said the company is at a turning point, as "layers of pressures that ...
User at modem A issues a dial command: AT-Get the modem's ATtention; D-Dial; T-Touch-Tone; 12125550100-Call this number RING: Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect".