Search results
Results from the WOW.Com Content Network
Air flow control (CAV or VAV air handlers) Zone control (single zone or multi zone air handlers) Fan location (draw-through or blow-through) Direction of outlet air flow (front, up, or down) Package model (horizontal or vertical) But, the first method is very usual in HVAC market. In fact, most of the company advertise their products by air ...
In lieu of payment, Lennox accepted their patent, obtaining rights to the idea and founded the Lennox Furnace Co. [2] In 1904, DW Norris acquired the company. He managed the company until his death in 1949. [3] From 1964-65, Lennox produced a small crawler tractor and mower called the Lennox Kitty Track 600.
A centrifugal fan is a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid. Centrifugal fans often contain a ducted housing to direct outgoing air in a specific direction or across a heat sink; such a fan is also called a blower, blower fan, or squirrel-cage fan (because it looks like a hamster wheel).
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
HVAC system design is a subdiscipline of mechanical engineering, based on the principles of thermodynamics, fluid mechanics, and heat transfer. "Refrigeration" is sometimes added to the field's abbreviation as HVAC&R or HVACR, or "ventilation" is dropped, as in HACR (as in the designation of HACR-rated circuit breakers).
The airflow is then reversed, so that the hot bricks heat up the incoming combustion air and fuel. For a glass-melting furnace, a regenerator sits on either side of the furnace, often forming an integral whole. For a blast furnace, the regenerators (commonly called Cowper stoves) sit separate to the furnace. A furnace needs no less than two ...
In a water boiler, draft is the difference between atmospheric pressure and the pressure existing in the furnace or flue gas passage. [1] Draft can also be referred to as the difference in pressure in the combustion chamber area which results in the motion of the flue gases and the air flow.
Redundancy: If one zone furnace fails, the others can remain working; Disadvantages: Cost. Furnaces cost much more than zone dampers; Power consumption. Operating furnaces draw power whereas a zone damper only draws power while in motion from one state to the other (or, in some cases, a very small amount of power while holding closed)