Search results
Results from the WOW.Com Content Network
At 20 °C and 101.325 kPa, dry air has a density of 1.2041 kg/m 3. At 70 °F and 14.696 psi, dry air has a density of 0.074887 lb/ft 3. The following table illustrates the air density–temperature relationship at 1 atm or 101.325 kPa: [citation needed]
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound. The symbol g 0 is used to denote standard gravity in order to avoid confusion with the (upright) g symbol for gram.
convert CAS to equivalent airspeed (EAS) by allowing for compressibility effects (not necessary at slow speed or low altitude); EAS is used by aircraft engineers and some very high-altitude flying aircraft such as the U-2 and the SR-71; convert EAS to true airspeed (TAS) by allowing for differences in density altitude.
Toggle the table of contents. Air velocity ... Air velocity may ... the speed of the air currents; Airspeed, the speed of an aircraft relative to the air. See also ...
In aviation, equivalent airspeed (EAS) is calibrated airspeed (CAS) corrected for the compressibility of air at a non-trivial Mach number. It is also the airspeed at sea level in the International Standard Atmosphere at which the dynamic pressure is the same as the dynamic pressure at the true airspeed (TAS) and altitude at which the aircraft ...
Siacci found that within a low-velocity restricted zone, projectiles of similar shape, and velocity in the same air density behave similarly; or . Siacci used the variable for ballistic coefficient. Meaning, air density is the generally the same for flat-fire trajectories, thus sectional density is equal to the ballistic coefficient and air ...
L. Use of the Terms "Mass" and "Weight" [See Section K. NOTE] When used in this handbook, the term "weight" means "mass". The term "weight" appears when inch-pound units are cited, or when both inch-pound and SI units are included in a requirement. The terms "mass" or "masses" are used when only SI units are cited in a requirement.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...